top of page
Jewelry Cleaning Tips from LOCKYUEN

Jewelry Cleaning Tips

If the jewelry is contaminated or tarnished, it must be cleaned by corresponding methods.

 

To remove fingerprints, light grease or dirt, add a small amount of mild liquid soap to a half cup of warm water, soak 2-3 minutes, rinse thoroughly with clean water and dry completely before storing in an air tight plastic bag.

Be very careful when using any soaking method to clean jewelry that has soft stones such as amber, lapis lazuli, or turquoise. Extended soaking in any solution may harm the polish on the stone. Never use chlorine bleach or toothpaste to clean to clean jewelry.

 

To remove excessive tarnish, polish with a 100% cotton cloth and a good nonabrasive metal cleaner. Be sure to remove any remnants of the cleaner from gemstones and rinse thoroughly with clean water. 

SILVER JEWELRY CLEANING TIPS

LOCK YUEN Own Way Snake Silver Bracelet

When cleaning sterling silver remember that it is a very soft metal and can easily be marred by a fingernail or wadded piece of fabric pushed roughly against the metal surface. For this reason, use one of the following methods to clean heavier soils and tarnish :

Using a small amount of silver jewelry cleaner on a soft cloth, gently rub the silver several times. Then rinse the silver thoroughly in warm water and carefully dry. This will remove the tarnish and dullness, keeping your sterling silver like new. Please note: chlorine and bleach accelerate tarnishing and should be avoided.

 

An oxidized finish is the deliberate blackening of crevices in the ornamentation of a silver object to make its decorative details stand out more clearly. Take care as this finish can be removed by overzealous cleaning and polishing.

When silver jewellry turns yellow or oxidized so badly, it can be soaked in silver jewelry cleaner for a few seconds to one minute generally, then take it out and wash it with water immediately, then wipe it with a silver polish cloth after it has dried.

bottom of page